Steps To Fuel An Airplane Using An Aircraft Maintenance Ladder

Steps To Fuel An Airplane Using An Aircraft Maintenance Ladder

by Eugenia Dickerson

Putting fuel to an airplane is not an easy job because it is not the same as filling up other vehicles. You have to follow a set of instructions so you will be equipped with the knowledge of refueling one and ensuring that it will land safely. You can use an aircraft maintenance ladder so you can reach the pit and calculate the amount you have to produce.

With every plane, there are different kinds of fuel grade. You have to determine which one you need to use. Check the make and model and go through the documents which can prove what it will be needing. You can also ask the crew about what is typically used with the vehicle you will be assisting.

Another important thing you should be aware about is the kind of fuel you will fill. Most of them do not carry the same diesel. One aircraft can be exclusively run on a different brand. This will always depend on what will withstand the length of the flight and the distance they will be going to.

You have to be able to connect the ground wire with the aircraft you are handling. Find out which tools you should be using as you install this. Be careful in setting the wires to its places so it will function well when you are manipulating the controls.

If the wings of the aircraft are higher than what it normally is, you have to put the maintenance ladder in front of the cap for the fuel. This should be situated in the farthest fuel tank. Locate where it is standing before you set the ladder into place.

Be able to drag the hose out and reach it as far as you need it to be. This will help you as you start refueling. Choose the one that can reach the cap especially if it is put up high in the side. You will need assistance in dragging the hose out of the safety volt.

Start to remove the cap from where you are standing on. You can see that it is not how you fill your car. For those planes which are larger, the wings must be refueled first. This is because it will need balance to keep the plane together. Before you start, you have to make sure that all the valves have been opened up correctly.

If the valves are not opened in place, you have to check this with your pilot or the maintenance associates. Go to the sides where the wings are before you go to the central tank. When you are done, reinstall all the caps and close each panel securely. Be ready to wind up the hose of the fuel.

Start by winding up all ground wires. Carefully inspect the cap if it has been shut off securely. Check if the water is put together with the fuel. Inspect this before you start and while you are refueling. As you hold the hose, touch out the nozzle and set it in the lip of the engine so it will flow in two paths. When you go around its tail, utilize an <A href="http://www.locknclimb.com">aircraft maintenance ladder</A> to successfully finish the procedure.



You can visit the website <a href="http://www.locknclimb.com">www.locknclimb.com</a> for more helpful information about Steps To Fuel An Airplane Using An Aircraft Maintenance Ladder

---------------------------------------------------
You are receiving this because you signed up for it on 2012-04-22 from IP 114.79.13.119
To fine-tune your selection of which articles to receive, just login here:

http://www.uniquearticlewizard.com/bloggers/

using your username:

To unsubscribe please use the following link:

http://www.uniquearticlewizard.com/unsubscribe.php?mail=wisatanusantara3.alankoesumah@blogger.com&code=d48035f43fb1db56998290ec5232b52c
---------------------------------------------------